Setting Battery Charge Controls; Setting Battery Jump/Crank Assist Controls - Miller Bobcat 200 Air Pak Diesel Owner's Manual

8-4. Setting Battery Charge Controls

2
1
Ref. 281606

8-5. Setting Battery Jump/Crank Assist Controls

2
1
.
A complete Parts List is available at www.MillerWelds.com
!
Have only qualified persons
charge batteries.
!
Never place 12V battery on 24V
only setting.
1 Charge/Weld Switch
Place switch in charge position.
2 Process Switch
Place switch in position matching voltage
of battery being charged. Weld power is
not available in battery charge mode.
.
Battery output is not energized until
battery is checked by unit.
.
Charging current automatically stops
when terminal current is below five
amps for five minutes.
Start engine and charge battery for 10
minutes. Check battery voltage. Continue
charging if necessary.
!
Stop engine when finished charg-
ing. Stand as far from battery as
practical and disconnect charging
cables from unit. Remove charg-
ing cables from battery Negative
(−) cable first.
!
Always disconnect battery charge
plug before removing clamps.
Clamps may be energized when
unit is in battery charge mode.
!
Have only qualified persons
jump/crank assist batteries.
1 Charge/Weld Switch
Place switch in charge position.
2 Process Switch
Place switch in position matching
voltage of battery being crank assist-
ed. Weld power is not available in bat-
tery charge mode.
.
Battery output is not energized
until battery is checked by unit.
NOTICE − Do not attempt to crank en-
gine for intervals longer than 20 sec-
onds. Output will shut down and will
reset when unit has cooled.
!
Stop engine when finished
charging. Stand as far from
battery as practical and dis-
connect charging cables from
unit. Remove charging cables
from battery Negative (−) cable
first.
Ref. 281606
OM-281710 Page 41