How To Use The Remote Control - BEA LZR-FLATSCAN W Manual

HOW TO USE THE REMOTE CONTROL

After unlocking, the red LED
flashes and the sensor can be
adjusted by remote control.
It is recommended to use a different access code for each sensor in order to avoid changing settings on
both sensors at the same time.
SAVING AN ACCESS CODE
The access code is recommended for sensors installed close to each other.
DELETING AN ACCESS CODE
ADJUSTING ONE OR MORE PARAMETERS
CHECKING A VALUE
RESTORING TO FACTORY VALUES
Page 4 of 12
If the red LED flashes quickly after unlocking, you need
to enter an access code from 1 to 4 digits.
If you do not know the access code, cycle the power.
During 1 minute, you can access the sensor without
introducing any access code.
Enter the existing code
x = number of flashes = value of the parameter
2x 1x
full reset partial reset
75.0050.01 LZR-FLATSCAN W 20230908
To end an adjustment
session, always lock the
sensor.
x
= field width: 2.35 m
3x 1x 5x