How To Use The Remote Control - BEA LZR FLATSCAN SW User Manual

HOW TO USE THE REMOTE CONTROL

After unlocking, the red
LED flashes and the sensor
can be adjusted by remote
control.
It is recommended to use a different access code for each module
in order to avoid changing settings on both modules at the same time.
SAVING AN ACCESS CODE
The access code is recommended for sensors installed close to each other.
DELETING AN ACCESS CODE
Enter the existing code
ADJUSTING ONE OR MORE PARAMETERS
CHECKING A VALUE
RESTORING TO FACTORY VALUES
10
If the red LED flashes quickly after unlocking, you
need to enter an access code from 1 to 4 digits.
If you do not know the access code, cut and restore
the power supply. During 1 minute, you can access
the sensor without introducing any access code.
x
x = number of flashes = value of the parameter
2x 1x 3x
partial reset
full reset
To end an adjustment session,
always lock the sensor.
= field width: 2.35 m
1x 5x