How To Use The Remote Control - BEA LZR FLATSCAN S User Manual

HOW TO USE THE REMOTE CONTROL

Before using the remote control, please check the following points:
1. The max. distance between the sensor and the remote control is 4 m.
2. The sensor's curtain should not be perpendicular to a high reflective surface. A 3-degree angle is necessary between them
to guarantee communication between the sensor and the remote control.
3. The authorized operator or installer can set a password to avoid unwanted modifications in the chosen settings
After unlocking, the red LED
flashes and adjustments can
be made by remote control.
ADJUSTING ONE OR MORE PARAMETERS
CHECKING A VALUE
RESTORING TO FACTORY VALUES
SAVING AN ACCESS CODE
An access code is recommended for sensors installed close to each other.
The setting will take effect 1 minute later.
DELETING AN ACCESS CODE
After power on, you have 1 minute to choose this setting.
30 minutes after last use, the sensor locks the access to the remote control session.
Cut and restore power supply : the remote control session will be accessible again during 30 minutes.
6
If the red LED flashes quickly after unlocking, you
need to enter an access code (1 to 4 digits).
x
X = THE NUMBER OF FLASHES INDICATES THE VALUE OF THE PARAMETER.
To end an adjustment session,
always lock the sensor.
x
= field width: 4.2 m
4
1 2
teach-in