Via Remote Control; Access Code - BEA EAGLE ARTEK Manual

SETTINGS
FIELD SIZE
FIELD SHAPE
MOUNTING
HEIGHT
IMMUNITY
FILTER
DETECTION
MODE
OUTPUT
CONFIG
HOLD-OPEN
TIME
DOOR
CONTROL
FACTORY
RESET

ACCESS CODE

The access code (1 to 4 digits) is recommended to set sensors installed close to each other.
Saving an access code:
Deleting a known access code:
Deleting an unknown access code:
Once you have saved an access code, you must always enter this code to unlock the sensor.
If you forget the access code, cut and restore the power supply. Within 1 minute, you can access the sensor
without introducing any access code.
Page 8 of 12

via REMOTE CONTROL

XXS XS S
= wide (default)
= narrow
To query the specific width, press
The sensor will blink the number of times that it is set to, and then the green LED will
blink either 1 time (narrow shape) or 2 times (wide shape).
Example: If FIELD SIZE = large and FIELD SHAPE = narrow, the LED with blink 7 times,
and then 1 time.
> 10 ft
< 10 ft
normal
low
bi
uni
NO NC
0.5 s 1 s 2 s
auto open
> > >
.
high
> >
uni MTF &
uni MTF
AWAY AWAY
3 s 4 s 5 s
closed
FACTORY VALUES:
> L XL
> > >
bi = two-way detection
uni = one-way detection towards sensor
uni MTF = one-way detection with
motion-tracking feature
uni AWAY = one-way detection away
from sensor
6 s 7 s 8 s
open = sensor detects constantly, LED on
closed = sensor is in standby and does not
detect, LED off
full
* outputs are not reset
75.0072.02 EAGLE ARTEK 20231023
XXL
highest
9 s
partial *