How To Use The Remote Control - BEA LZR- FLATSCAN REV-PZ User Manual

HOW TO USE THE REMOTE CONTROL

After unlocking, the red LED
flashes and the sensor can
be adjusted with the remote
control.
When there are several sensors it is recommended to use a different access code for each sensor in order to avoid
changing settings on all of them at the same time.
ADJUSTING ONE OR MORE PARAMETERS
CHECKING A VALUE
DETECTION FIELD ADJUSTMENT
increase/decrease the detection field of 1cm.
TEACH-IN
* refer to the teach-in process on page 6.
8
If the red LED flashes quickly after unlocking, you
need to enter an access code from 1 to 4 digits.
If you do not know the access code, cut and restore
the power supply. During 1 minute you can access
the sensor without introducing any access code.
To end an adjustment session,
always lock the sensor.
x
x = number of flashes = value of the parameter
2x 1x 3x
Launch detection field Teach-in*
Launch environment learning*
= field width: 2.35 m
1x 5x