Advertisement
LED SIGNALS
ACTIVITY
LED flashes quickly
COLOR INDICATIONS
none = no detection
HOW TO USE THE REMOTE CONTROL
ADJUSTING ONE OR MORE PARAMETERS
red
CHECKING A VALUE
red
SAVING AN ACCESS CODE
The access code (1 to 4 digits) is recommended to set sensors installed close to each other.
Once you have saved an access code, you always need to enter this code to unlock the sensor.
If you forget the access code, cycle the power. For the first minute, you can access the sensor without an
access code.
DELETING AN ACCESS CODE
DELETING AN UNKNOWN ACCESS CODE
HOW TO USE THE PUSH BUTTONS
75.5863.04 PHOENIX EX 20210701
LED flashes
red = detection
You must unscrew the explosion-proof cover to access the push buttons.
To do so, loosen the set screw and then unscrew the lid.
START/END AN ADJUSTMENT SESSION: press and hold either push button until the
LED flashes or stops flashing
SCROLL THROUGH PARAMETERS: press the right push button
CHANGE VALUE OF CHOSEN PARAMETER: press the left push button
RESET TO FACTORY VALUES: press and hold both push buttons until both LEDs flash
LED flashes slowly
X
red
red
green
x = number of flashes = value of parameter
LED flashes x times
red/green = power on / learn
red
X
LED is off
off
off
Page 3 of 8
Advertisement
