Vcc - Led; Net St - Led; Dev St - Led; Opt - Led - KEB COMBIVERT F6 Instructions For Use Manual

3.11.2 VCC - LED
3.11.3 NET ST - LED
3.11.4 DEV ST - LED
3.11.5 OPT - LED
Tip
ma_dr_f6-cu-a-inst-20118593_en
LEDs Status
VCC ready for operation
NET ST
DEV ST
OPT
Tab. 3: LEDs at power on
VCC LED colour Description
off - Power supply of the control card switched off.
on green Control is supplied with 24 V.
Tab. 4: Function VCC LED
NET ST LED colour Description
off - Device off or booting.
on yellow During switching on, if FPGA is booted.
Blink various depending on fieldbus => fieldbus interfaces.
code
Tab. 5: Function NET ST - LED
DEV ST LED colour Description
OFF - Device off or in boot process.
ON Red Error
ON Yellow No error, DC bus not charged.
ON Green No error, ready for operation.
Flashing Green No error, serves to identify the device (fb.32).
Tab. 6: Function DEV ST - LED
OPT LED colour Description
- - reserved for options.
Tab. 7: Function OPT - LED
The DEV ST and OPT LEDs can be re-programmed for diagnostic purposes
(i.e., the OPT LED could be programmed to represent the status of one of
the digital inputs).
Refer to the Configuration Handling parameters in the programming
manual.
Product description | 3
Note
Device is ready for operation and the LEDs start
with their normal function (approx. 3 s)
15