Symbols And Markers; Laws And Guidelines; Warranty And Liability; Support - KEB COMBIVERT F6 Instructions For Use Manual

1 | Introduction
1.1.3 Symbols and markers
1.2 Laws and guidelines
1.3 Warranty and liability
1.4 Support
8
Notes on conformity for use in the North American or Canadian mar-
ket.
✓ Condition
a) Action step
➾ Result or intermediate result
(≡► Reference Reference to a chapter, table or picture with page reference
[} 8])
ru21 Parameter name or parameter index
Hyperlink
(► )
Control code
<Strg>
COMBIVERT Lexicon entry
KEB Automation KG confirms with the CE mark and the EU declaration of conform-
ity that our device complies with the essential safety requirements.
The EU declaration of conformity can be downloaded on demand via our website.
The warranty and liability on design, material or workmanship for the acquired
device is given in the general conditions of sale.
Here you will find our general sales conditions.
(► https://www.keb-automation.com/terms-conditions)
Further agreements or specifications require a written confirmation.
Through multiple applications, not every possible case has been taken into ac-
count. If you require further information or if problems occur which are not treated
detailed in the documentation, you can request the necessary information via the
local KEB Automation KG agency.
The use of our units in the target products is beyond of our control and
therefore exclusively the responsibility of the customer.
The information contained in the technical documentation, as well as any support
provided verbally, written or through testing, is made to the best of our knowledge
and information regarding intended use of KEB products. However, due to tech-
nical changes, any information provided is considered non-binding and is subject to
change. This also applies to any violation of industrial property rights of a third-
party.
Selection of KEB units in view of their suitability for the intended use must be done
by the user.
Tests can only be carried out within the scope of the intended end use of the
product (Application) by the Customer. They must be repeated, even if only
parts of hardware, software or the unit adjustment are modified.
KEB Automation KG
ma_dr_f6-cu-a-inst-20118593_en