Table of Contents
Advertisement
GE M
S
EDICAL
YSTEMS
D
2300000, R
IRECTION
EVISION
8-11-1
Installing Base Software Load Image CD
15.). Approx. ten (10) minutes later, the gray colored screen appears. Eject the " Base Software Load
Image CD Disk 1 of 2 " from the drive and Insert the " Base Software Load Image CD Disk 2 of
2". And then Select to 'OK' button to continue.
16.)Approx. ten(10) minutes later, the following screen appears. Eject the" Base Software Load Image
CD 2 of 2" from the drive
17.)After removing the CDROM from the drive, Press ALT + CTRL + DEL key
18.)Turn on the system.
NOTE:
After installation Base Software Load Image CDs, the "General failure reading drive A .. Abort,
Retry, Fail?" message can be appeared, but Ignore it! All procedure would be successfully done
NOTE:
Remove the CD-ROM from the drive. Otherwise you will be repeating the Base System
Software Load process.
2
Figure 8-222 Span Volume [1] Done
Figure 8-223 Screen
Chapter 8 Replacement Procedures
LOGIQ™5 S
(cont'd)
M
ERVICE
ANUAL
8-183
Advertisement
Table of Contents
