GE LOGIQ 5 Service Manual page 374

Hide thumbs Also See for LOGIQ 5:

Table of Contents

Section 8-11

Installing Base Software Load Image

Installing Base Software Load Image CD

While we do not believe it is necessary, It would not hurt to disconnect the system from the

network and remove all transducers.

1.) Power ON the scanner.

2.) Tap gently the DEL key until the following screen appears.Enter jupiter as a password if the system

request a password, then press the Enter key.

3.) The Setup Utility screen appears. Using arrow keys, Select Advanced Tab and select USB

Configuration and then press the Enter key. Verify that High-Speed USB is Enabled. If it is

disabled, using arrow keys, select High-Speed USB and press the Enter key and change it

4.) To exit USB Configuration, press ESC key.

Figure 8-214 Enter Current Password

Figure 8-215 USB Configuration

Section 8-11 - Installing Base Software Load Image