Hydraulic Reservior-Bleeder Filter Check; Diesel Engine - Oil And Filter Change - Fayat Group DYNAPAC CA25 Instruction Manual

1
Fig. 1. Water Separator
1
Fig. Hydraulic fluid tank
1. Filer cap/air filter.
2. Oil sight glass.
Fig. Left side of engine:
1. Drain plug;
10-03-2022
Water Separator Replacement
Remove the threaded water separator using the filter wrench.
Lubricate the O ring with clean lubricating oil.
Do not prefill the engine water separator.
Install the water separator on the filter head. Rotate the water
separator until the seal touches the surface of the filter head.
Rotate the fuel filter another 3/4 of a revolution after contact.
The air needs to be removed from the fuel system after water
separator installation.
Hydraulic reservoir – bleeder filter check
2
If passage in either direction is blocked, clean the
filter with a little diesel oil and blow through with
compressed air until the block is removed, or replace
the cap with a new one.
Start the engine and check that there is no leakage of the
hydraulic fluid from the filter. Check level of fluid in the slight
glass (2) and top up as required.
Diesel engine – Oil and filter change
Take great care when draining fluid and oil at high
temperatures. Wear protective gloves and goggles.
It is easier to handle the oil drain plug (1) from under the
engine. Drain the oil when the engine is warm. Place a
receptacle that holds at least 15 litres (4 gal) under the drain
1
plug.
4812330982EN
Maintenance – Planned maintenance
Check the procedure for removing the air in the engine
manual.
Always wear protective goggles when working
with compressed air.
Check that the bleeder filter (1) is not clogged. Air
should be able to pass through the cap unobstructed
in the both directions.
Change the oil filter. Please read the instruction manual
for the engine.
Dispose of the drained oil and filter separately in the
right manner.
99