Safety - During Operation; Operation Near Edges; Slope - Fayat Group DYNAPAC CA25 Instruction Manual

Minimum 2/3
Fig. Positioning of the drums when
driving near an edge of a slope.
Fig. Operation on slopes
10-03-2022
Safety – During operation

Operation near edges

When driving near edges, at least 2/3 of the machine's width
should be on ground with full bearing strength.
Slopes
This angle has been measured on a hard, flat surface with
the machine stationary.
The steering angle was zero, the vibration was switched off
and all tanks were full.
Always take into consideration that loose ground, steering
the machine, vibration on, machine speed across the
ground and raising the centre of gravity can all cause the
machine to topple at smaller slope angles than those
specified here
ₒ
or
4812330982EN
Special instructions
Remember that the machine's centre of gravity
moves outward when steering. For example: it
moves right when you steer left.
.
To exit the cab in an emergency, release the
hammer located on the rear right post and
break the rear window.
It is recommended that ROPS (Roll Over
Protective Structure) or a ROPS approved
cab is always used when driving on
slopes or unstable ground. Always wear a
safety belt.
Avoid driving across slopes.
Always drive straight up and down on
slopes.
14