Fig. Engine Compartment
1.
Fuel strainer
2.
Hose clamp
1
Fig. 1. water Separator.
2
3
Fig. Check oil level – drum gearbox
1.
Drain plug
2.
Filler plug
3.
Level plug
10-03-2022
Maintenance – Planned maintenance
Fuel Strainer cleaning
Ensure good ventilation (air extraction) if the
diesel engine is run indoors. Risk of carbon
monoxide poisoning.
Loosen the hose clamp (2) and remove the strainer (1).
Clean the Strainer (1), taking care to fit in the direction of flow.
Discard the Strainer (1) in a safe manner, its of
expandable type and cannot be cleared.
Start the engine and check that the Strainer does not leak.
Water Separator Replacement
Remove the threaded water separator using the filter wrench.
Lubricate the O ring with clean lubricating oil.
Do not prefill the engine water separator.
Install the water separator on the filter head. Rotate the water
separator until the seal touches the surface of the filter head.
Rotate the fuel filter another 3/4 of a revolution after contact.
The air needs to be removed from the fuel system after water
separator installation.
Check the procedure for removing the air in the engine manual.
Drum gearbox (D/PD) – Changing the oil
(Applicable to CA25D and CA30D)
(No need to change oil in CA35D)
Wipe clean, unscrew the plugs (1, 2 and 3) and drain the oil into
a suitable receptacle with a capacity of about 2.5 litres (2.6 qts).
Refit the drainage plug (1) and top up with oil up to the level
plug (3).
Ensure that the oil level reaches up to the lower edge of the
plug opening.
1
Replenish the oil to the right level if the level is low. Use
transmission oil (see lubricant specifications).
Clean and refit the plugs.
4812330982EN
109