Bolted Joints - Checking Tightening; Rubber Element And Fastening Screws; Diesel Engine - Oil And Filter Change - Fayat Group DYNAPAC CA25 Instruction Manual

Fig. Right side of machine
1. Steering Pump
2. Rear Axle
3. Engine shock mount
4. Wheel nut
Fig. Drum, vibration side
1. Rubber element
2. Attachment screws
1
Fig. Left side of engine:
1. Drain plug;
10-03-2022
Maintenance – Planned maintenance
Bolted joints – Checking tightening
Steering pump for the diesel engine (1) 55 Nm, lightly oiled.
Rear axle suspension (2), 330 Nm (243 ft/lbf) oiled.
Engine shock mount (3). Check that all the M12 bolts (20
pieces) are tightened with 70 Nm and lightly oiled.
Wheel nuts (4). Check that all nuts are tightened, 630 Nm, and
oiled.
(The above applies to new or replaced components only).
Rubber elements and fastening screws
Check all rubber elements (1), replace all of the elements if
more than 25% of them on one side of the roller are cracked
deeper than 10-15 mm.
Use the blade of a knife or pointed object to help you check.
Make sure as well that the fastening screws (2) are tightened.
Diesel engine – Oil and filter change
Take great care when draining fluid and oil at high
temperatures. Wear protective gloves and goggles.
It is easier to handle the oil drain plug (1) from under the
engine. Drain the oil when the engine is warm. Place a
receptacle that holds at least 15 litres (4 gal) under the drain
plug.
Change the oil filter. Please read the instruction manual for the
engine.
Dispose of the drained oil and filter separately in the
right manner.
4812330982EN 95