Table of Contents
Advertisement
Figure 26. Removing front drive bay backplane
NOTE:
To avoid damaging the backplane, ensure that you move the control panel cables from the cable routing clips
before removing the backplane.
Next steps
Install the
backplane.
Installing the front drive bay backplane
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the
drives.
4. Disconnect the cables from the backplane.
NOTE:
To avoid damaging the backplane, ensure to move the control panel cables from the cable routing clips before
removing the backplane.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the backplane to the guide hooks on the system.
2. Insert the backplane into the hooks till the blue release tabs click in place.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Safety
instructions.
Before working on your
system.
Installing and removing system components
61
Advertisement
Table of Contents
