Connect Ethernet Cable; Enb Grounding; Connect Grounding Cables; Figure 3-10: Connect Cables And Grounding Screws - Baicells Nova430i Installation Manual

Outdoor 4x250mw two-carrier tdd enodeb

Hide thumbs Also See for Nova430i:

Table of Contents

Nova430i Outdoor 4x250mW Two-Carrier TDD eNodeB Installation Guide

3.3.2 Connect Ethernet Cable

Refer to Figure 3-10 to complete the Ethernet cable connection.

1. Connect the Ethernet cable to the Ethernet (ETH) interface in the wiring cavity.

2. Lay the Ethernet cable along the wire groove, and stretch out the wiring cavity from the Ethernet

(ETH) hole.

3. The Ethernet cable connects to the PoE interface of the PoE adapter.

4. The LAN interface of the PoE adaptor connects to a LAN switch or a router for maintenance and

backhaul.

NOTE: The PoE adaptor must be placed in the distribution box for waterproofing.

Prepare the grounding cable according to the actual measurements and requirements of the specific

installation site. The Nova430i eNB has two grounding screws on the bottom of the unit, as shown in

Figure 3-10. Follow the steps below to connect the ground cable.

NOTE: All Nova eNBs have a floating ground on the power system.

1. Unscrew one grounding screw, connect one end of the ground cable to the grounding screw, and

retighten the screw.

2. Repeat

step 1

for the second grounding screw.

3. Once the eNB is installed at the outdoor location, the other end of the ground cable needs to

connect to a good grounding point (earth).

Table of Contents

Pbs3101s