Table of Contents
Advertisement
Introduction
There are three ways to configure the HR52: Barcode programming, command programming and Easyset programming.
Barcode Programming
The HR52 can be configured by scanning programming barcodes. All user programmable features/options are described
along with their programming barcodes/commands in the following sections.
This programming method is most straightforward. However, it requires manually scanning barcodes. As a result, errors
are more likely to occur.
Command Programming
The HR52 can also be configured by serial commands (HEX) sent from the host device.
Users can design an application program to send those command strings to the scanners to perform device configuration.
EasySet Programming
Besides the two methods mentioned above, you can conveniently perform scanner configuration through EasySet too.
EasySet is a Windows-based configuration tool particularly designed for Newland products, enabling users to gain access
to decoded data and captured images and to configure scanners. For more information about this tool, refer to the EasySet
User Guide.
Before programming the scanner, you need to pair it to a cradle first. When programming the scanner
with serial commands or EasySet, you need to insert it in the paired cradle.
17
Chapter 3 System Settings
Enter Setup
** Exit Setup
Advertisement
Table of Contents
