Chapter 2 System Settings; Introduction; Barcode Programming; Command Programming - Newland NLS-HR1050-7 Series User Manual

** Enter Setup

Introduction

There are two ways to configure the scanner: barcode programming and command programming.

Barcode Programming

The scanner can be configured by scanning programming barcodes. All user programmable
features/options are described along with their programming barcodes/commands in the following
sections.

Command Programming

Besides the barcode programming method, the scanner can also be configured by serial commands sent
from the host device. Note that communication parameters on the scanner and the host must match so
that two devices can communicate with each other. The default settings of the scanner are 9600bps, no
parity check, 8 data bits, 1 stop bit, and no flow control. The scanner uses 8-bit registers.
Exit Setup

Chapter 2 System Settings

12