Table of Contents
Advertisement
Introduction
There are two ways to configure the scanner: barcode programming and command programming.
Barcode Programming
The scanner can be configured through scanning programming barcodes. In the following sections, we
will explain the available options and features and provide the barcodes to program them.
This programming method is most straightforward. However, it requires manually scanning barcodes. As
a result, errors are more likely to occur.
Command Programming
The scanner can also be configured by command strings sent from the Host. In the following sections, the
commands will be provided along with programming barcodes.
Users can also design an application to send those command strings to their scanners.
Note: All settings except temporary ones are stored in non-volatile memory of the scanner and
will not be lost by removing power from the scanner.
15
Chapter 2 System Settings
【Enter Setup】
**【Exit Setup】
Advertisement
Table of Contents
