Table of Contents
Advertisement
T S - 8 0 U S E R G U I D E
RECEIVING CALLS
When receiving calls, your phone will ring and the display will show caller
identity information if you are subscribed to Caller ID service.
To answer an incoming call,
1. Lift the handset, or
SPEAKER
2. Press the
HANGING UP A CALL
You can hang up a phone call by pressing the
phone mode or by putting the handset back in the cradle.
PUTTING A CALL ON HOLD
1. You can put a call on hold by pressing the
is on hold, you can hang up your phone without losing the call.
2. In order to get re-connected to a call that you previously put on hold, you
must first lift the handset or press the
HOLD/FLASH
Note: A call that was put on hold at a specific extension can only be retrieved
from the same extension. In order to be able to re-connect to the call from a
different extension, you would need to use the call PARK and UNPARK functions.
See the Parking a Call section on page 11 for more information.
CALL WAITING AND QUEUED CALLS
When on a call, it is possible to receive another call if your extension is configured
for call waiting as the chosen action in the busy call handling option of the
TalkSwitch PBX. It is also possible to automatically queue incoming calls to your
extension or ring group.
If you receive a call waiting notification while on a call, you will hear a call
waiting tone, see the WAITING indicator on the display as well the Caller ID of
the call waiting. If a call gets queued on your line, you will hear the call queued
tone. You can answer the call waiting or queued call and put the current caller
on hold by pressing the
between calls by repeatedly using the
1 0
button to answer the call in speakerphone mode.
button again. You will be reconnected to your previous call.
HOLD/FLASH
SPEAKER
HOLD/FLASH
SPEAKER
button, then press the
7
button then
. It is possible to switch
HOLD/FLASH
button and
button while in speaker-
button. Once a call
7
.
W W W.T A L K S W I T C H . CO M
Advertisement
Table of Contents
