Reset To Factory Defaults; Blank Screen; Phone Doesn't Ring; No Dial Tone - Talkswitch TS-80 User Manual

T S - 8 0 U S E R G U I D E

Reset to Factory Defaults

If the basic reset cannot return to the phone to the normal operating condition,
you must restore to factory defaults. All information stored in memory will be
erased.
1. Disconnect the power cord from the phone.
2. Wait for 10 seconds.
3. Press and hold
4. When firmware version number is displayed, release the buttons.
5. Follow the installation procedures to select the language and to enter the
area codes.

BLANK SCREEN

• Verify that your power adapter is properly connected.

PHONE DOESN'T RING

• Verify that the ringer is not turned off. Check the ring volume switch at
the back of the phone phone is idle to turn the ringer on.
• Verify that the line cord is properly connected and that dial tone is
present when going off-hook.
• Verify that the TalkSwitch is properly programmed for your extension's
call handling.
• Verify that Do Not Disturb is disabled for your extension.

NO DIAL TONE

• Verify that the line cord is properly connected.
• Try with a different line cord.
• Test the telephone in a different jack. If it works, then the jack may be
defective or the TalkSwitch may be wired incorrectly.

NO CALLER ID

• Check Caller ID subscription. In order to receive Caller ID for external
calls, you must be subscribed to the Caller ID service from your
telephone service provider.
1 6
DELETE
when reconnecting the power cord to the phone.
W W W.T A L K S W I T C H . CO M