Setting Up The Lan Interface; Table 2-1 Specification Of The Lan Setting - Hitachi HF-W6500 Instruction Manual

2.8 Setting Up the LAN Interface

This equipment has two built-in 1000BASE-T／100BASE-TX／10BASE-T LAN ports.
For information about the location of the LAN port connector (1000BASE-T／100BASE-TX
／10BASE-T), see "1.5 Name and Function of Each Part".
< NOTE >
・ For information about the precautions for the network, see "PRECAUTIONS 2.
NETWORK".
● Automatic recognition of the network transfer speed or transfer mode
The LAN port has an auto-negotiation function to automatically recognize the network
transfer speed or transfer mode. For normal use, enable the auto-negotiation function.
(Especially when you use the WOL function. If the speed is fixed to 1000Mbps (auto-
negotiation), the WOL function cannot be used.)
If there is a compatibility issue with the connected hub, the auto-negotiation function may
not work properly and that may affect the communication with other terminals.
If the auto-negotiation function does not work properly, configure the LAN interface as
follows.
Specification of
the hub
10 Mbps／Half-
10 Mbps／Full-
100 Mbps／Half-
100 Mbps／Full-
1.0 Gbps
(*) How the setting is displayed is different depending on the OS and the
LAN port (including the optional LAN adapter) in use.

Table 2-1 Specification of the LAN setting

10 Mbps
duplex
10 Mbps
duplex
100 Mbps
duplex
100 Mbps
duplex
1.0 Gbps (1000 Mbps)
Specification of the LAN setting (*)
Speed
Auto Negotiation or
2-11
2. OPERATION
Duplex
Half Duplex
Full Duplex
Half Duplex
Full Duplex
Full Duplex