Table of Contents
Advertisement
6.3.6 Installing and removing an HDD／SSD
When you install or remove an HDD／SSD, make sure you do not cut your
fingers on the protrusions.
⚫
Put the HDD／SSD on a shock-absorbing material such as an antistatic
cushion even for a temporary task. If you put an HDD／SSD directly on a hard
surface such as a desktop, a failure or a shorter life span of the unit or loss of
data may result due to possible jarring or shock.
⚫
Never remove the screws on an HDD／SSD while the power to the unit is on.
Never hot-swap HDDs. If you do either of these, failure of the equipment or the
drive may result.
⚫
Before you replace an HDD／SSD, make sure you shut down the OS, unplug
the power cord from the outlet, and wait for at least one minute.
⚫
For the B model (SATA HDD software RAID1 hot swap model) and the
T model (SATA SSD software RAID1 hot swap model), when you need to
replace a failed HDD or SSD in RAID1 while the power is on, see "10.4.2
Recovery from a failure in one drive".
⚫
Install or remove an HDD／SSD only if necessary, for example, when you need
to replace an HDD／SSD due to failure. If you do it frequently, failure of the
equipment may result.
⚫
Fully insert an HDD／SSD. Loose contact and missing screws may result in
failure.
⚫
Do not give a shock to an installing HDD／SSD and the already mounted HDD
／SSD during installing. If you give a shock to an HDD, failure of the drive may
result.
⚫
Be careful when assembling the SSD into drive bay 3, please insert and
remove it straight. If you do not insert and remove it straight, it may not fit
properly.
(1) Before mounting or removing HDD／SSD
・Before starting to work, see "6.3.2 Before installing or removing components".
< NOTE >
For information about the precautions for the HDDs／SSDs, see
"PRECAUTIONS 4. HARD DISK DRIVES (HDD)s／SOLID STATE
DRIVER(SSDs)".
CAUTION
NOTICE
6-15
6. CHECKUP AND MAINTENANCE
Advertisement
Table of Contents
