Table of Contents
Advertisement
<Required action>
・If you mount the equipment in a chassis or on a desk, the temperature increase around
the equipment needs to be taken into consideration.
・The system clock and the like inside the equipment always operates using a backup
battery even when the power is off. Therefore, if you store the equipment at a
temperature outside the operating temperature range, you may need to reconfigure
system BIOS settings including the clock settings, when you start using the equipment
again. When you reconfigure system BIOS settings, follow the instructions in "5.6
BIOS Setup".
(6) OPERATING CONDITION
<Precautions>
• Before you move the equipment, be sure to disconnect the plug of the power cord from the
outlet and wait at least one minute.
• In order to prevent moisture condensation, when you move the equipment from outside
the building to inside, wait for at least four hours before using the equipment.
• The equipment is made of precision electronics components. Do not subject the equipment
to any vibration or shock.
• Do not sit on the equipment nor place anything on the equipment.
• During normal operation, do not turn off the display. Set it into the standby mode instead.
• During normal operation, do not touch the keyboard or mouse until the logon screen is
displayed when you turn on the equipment.
<Required action>
・We recommend that you remove the dust built up in the neighborhood of the device (in
particular, below the device), in the vents on the device , and on the front of the device
itself.
(7) ABNORMAL SOUNDS
<Specifications>
・When the power is turned on, you may hear a low-frequency humming noise. This is
caused by transient low-frequency vibrations of the chokes for suppressing high-
frequency noise or other components and does not affect the characteristics and life span
of the equipment.
(8) WARRANTY
<Specifications>
・The Manufacturer cannot guarantee for damage to data or application software caused
by hardware damage to the equipment.
・Use an operating system specified by the Manufacturer. The Manufacturer cannot
guarantee proper operation of the equipment if you use an operating system not specified
by the Manufacturer.
・This equipment is evaluated under the assumption that the hardware specified by the
Manufacturer is used. Therefore, when you install or replace hardware, use the hardware
specified by the Manufacturer. The manufacturer cannot guarantee proper operation of
the equipment if you use other hardware.
C-5
Advertisement
Table of Contents
