Table of Contents
Advertisement
2.7 Controlling the Power Using the LAN
The power for this equipment can be turned on from a remote device by way of the LAN.
This section explains WOL (Wake ON LAN), which is used for turning on the power for
the equipment through the LAN. When the power is turned on by using WOL, the equipment
is started by sending a Magic Packet™ frame to the LAN interface when the standby lamp
(STBY) is on.
In the initial factory settings, this function is disabled. If you want to use this function,
follow steps 1 through 3 described in "2.7.1 Enabling the WOL (Wake ON LAN) function"
to enable the WOL function and then follow the steps below.
< NOTE >
・ For information about the precautions for the network, see "PRECAUTIONS 2.
NETWORK".
2.7.1 Enabling the WOL (Wake ON LAN) function
By following the procedure below, you can set up whether to start WOL when a Magic
Packet™ frame is received. In the initial factory settings, the WOL function is disabled.
1. Click Start > Intel. Right-click Intel(R) PROSet Adapter Configuration Utility. Then
click More > Run as administrator.
2-7
2. OPERATION
Advertisement
Table of Contents
