Table of Contents
Advertisement
The foundation requirements are based on generally accepted data on the site and the wind
force that will hit the surface (inland wind load zone 3). Adjust the foundation if there are
different requirements at a location. The customer is responsible for the correct dimensions
of a foundation.
NOTE
Maximum interface height 1.5 m
Position the charging station so that the electrical interfaces are no more than 1.5 m above
the ground.
4.2
Preparation before assembly
Requirements
• Follow country-specific statutory installation requirements.
• Prepare and position the concrete foundation according to the "foundation and
reinforcement plan" of the respective installation type.
– Foundation and reinforcement plan for standard version
– Foundation and reinforcement plan for option: HAK
• Anchor the four segment anchor rods or the mounting plate in the concrete foundation
according to the "Foundation and reinforcement plan" of the system type. Do not damage
the threads. Alternatively, prepare the fastening for installation according to the
dimensions of the "Foundation and reinforcement plan".
• When using empty pipes or corrugated pipes:
Cut the empty pipes or corrugated pipes at the top edge of the foundation.
• The power supply connection is available. At least 60 cm of cable is required for
installation above the top of the concrete foundation.
• All power supply connections are de-energized and secured against unintentional
reconnection.
• Optional:
Seal the empty pipes or corrugated pipes with a sealing compound or sealing sleeve.
Required tools
The required tools are not included in the scope of delivery.
• Combination wrench set up to 19 width across flats
• Key for housing (in the accessory kit)
• Spirit level
• Phillips head screwdriver set
• Slotted screwdriver set
• Tool set for electricians
• Allen key size 4, 5, 6
SICHARGE Operating Instructions MID
Operating Instructions, 02/2023, A5E48573001-AF
(https://support.industry.siemens.com/cs/ww/de/view/109780588)
(https://support.industry.siemens.com/cs/ww/de/view/109780588)
Mounting/assembly
4.2 Preparation before assembly
27
Advertisement
Table of Contents
