Dahua N41C1P User Manual page 52

Parameter
Default Ethernet Port
IP Version
DHCP
MAC Address
IP Address
Subnet Mask
Default Gateway
Description
of the two network adapters is disconnected, the system
network status is regarded as offline.
● Fault Tolerance
: Two network adapters share one IP address. Normally
only one network adapter is working. When this adapter
fails, the other network adapter will start working
automatically to ensure the network connection.
When you test the network status, the network is
◇
regarded as offline only when both network adapters
are disconnected.
The two network adapters are used under the same
◇
LAN.
● Load Balance
: Two network adapters share one IP address. The two
adapters work at the same time to share the network load
averagely. If one of them fails, the other can continue
working normally.
When testing the network status, the network is
◇
regarded as offline only when both of the two network
adapters are disconnected.
The two network adapters are used under the same
◇
LAN.
The Device with single Ethernet port does not support this
function.
Select IPv4 or IPv6. Both versions are supported for access.
Enable the system to automatically obtain a dynamic IP
address.
Displays the MAC address of the Device.
● Enter the IP address and then configure the corresponding
subnet mask and default gateway.
● After configuration, click Test to check whether there is
conflict in IP address.
IP address and default gateway must be on the same network
segment.
36
User's Manual