Table of Contents
Advertisement
● Only models with PoE ports support this function.
● Do not connect the PoE port with a switch, otherwise it will cause connection failure.
● This function is enabled by default, and the IP segment start from 10.1.1.1. We recommend
you use the default setting.
● When connecting to a third-party IPC, make sure that the IPC supports ONVIF protocol
and DHCP is enabled.
Procedure
Step 1
Select Main Menu > NETWORK > Switch.
Step 2
Configure IP address, subnet mask, and default gateway..
Do not set the IP address to the same network segment with the NVR. We
recommend you use the default setting.
Step 3
Click Apply.
Figure 5-201 Switch
243
User's Manual
Advertisement
Table of Contents
