Supermicro 7034A-T User Manual page 96

S W
UPER ORKSTATION 7034A-T/7034A-i Manual
Checkpoint
25h
27h
28h
2Ah
2Eh
2Fh
30h
31h
32h
34h
37h
38h
39h
3Ah
3Bh
40h
42h
43h
44h
45h
46h
47h
Code Description
Interrupt vector initialization is done. Clearing the password if the
POST DIAG switch is on.
Any initialization before setting video mode will be done next.
Initialization before setting the video mode is complete. Configuring
the monochrome mode and color mode settings next.
Bus initialization system, static, output devices will be done next, if
present. See the last page for additional information.
Completed post-video ROM test processing. If the EGA/VGA
controller is not found, performing the display memory read/write
test next.
The EGA/VGA controller was not found. The display memory read/
write test is about to begin.
The display memory read/write test passed. Look for retrace
checking next.
The display memory read/write test or retrace checking failed.
Performing the alternate display memory read/write test next.
The alternate display memory read/write test passed. Looking for
alternate display retrace checking next.
Video display checking is over. Setting the display mode next.
The display mode is set. Displaying the power on message next.
Initializing the bus input, IPL, general devices next, if present. See the
last page of this chapter for additional information.
Displaying bus initialization error messages. See the last page of this
chapter for additional information.
The new cursor position has been read and saved. Displaying the
Hit <DEL> message next.
The Hit <DEL> message is displayed. The protected mode memory
test is about to start.
Preparing the descriptor tables next.
The descriptor tables are prepared. Entering protected mode for the
memory test next.
Entered protected mode. Enabling interrupts for diagnostics mode
next.
Interrupts enabled if the diagnostics switch is on. Initializing data to
check memory wraparound at 0:0 next.
Data initialized. Checking for memory wraparound at 0:0 and finding
the total system memory size next.
The memory wraparound test is done. Memory size calculation has
been done. Writing patterns to test memory next.
The memory pattern has been written to extended memory. Writing
patterns to the base 640 KB memory next.
B-4