Table of Contents
Advertisement
Chapter 7: BIOS
Chapter 7
BIOS
7-1
Introduction
This chapter describes the AMIBIOS for the X6DAL-TG/X6DAL-G. The AMI ROM
BIOS is stored in a Flash EEPROM and can be easily upgraded using a floppy
disk-based program. This chapter describes the basic navigation of the AMI BIOS
Setup Utility setup screens.
Starting the BIOS Setup Utility
To enter the AMI BIOS Setup Utility screens, hit the <Delete> key while the
system is booting-up.
Note: In most cases, the <Delete> key is used to invoke the AMI BIOS setup
screen. There are a few cases when other keys are used, such as <F1>, <F2>, and
so on.
Each main BIOS menu option is described in this user's guide. The Main
BIOS setup menu screen has two main frames. The left frame displays all
the options that can be configured. "Grayed-out" options cannot be config-
ured. Options in blue can be configured by the user. The right frame dis-
plays the key legend. Above the key legend is an area reserved for a text
message. When an option is selected in the left frame, it is highlighted in
white. Often a text message will accompany it. (Note: The AMI BIOS has
default text messages built in. Supermicro retains the option to include, omit,
or change any of these text messages.)
The AMI BIOS setup/utility uses a key-based navigation system called hot
keys. Most of the AMI BIOS setup utility hot keys can be used at any time
during the setup navigation process. These keys include <F1>, <F10>, <En-
ter>, <ESC>, <Arrow> keys, and so on.
Note: Options printed in Bold are the default settings.
Note: fan speed is controlled by the "System Fan Monitor" setting in
BIOS. The recommended setting for the 7034A-T/7034A-i is "4-pin
(Workstation)" If you load the BIOS default settings this setting may
change. Therefore, if you do load BIOS defaults, you should reenter
BIOS setup and change this setting back to "4-pin (Workstation)", then
save and exit (see page 7-19).
7-1
Advertisement
Table of Contents
