Table of Contents
Advertisement
HDD LED
The HDD LED connection is located
on pins 13 and 14 of JF1. Attach the
hard drive LED cable to these pins to
display hard disk drive activity. Re-
fer to the table on the right for pin
definitions.
NIC LED
The NIC (Network Interface Con-
troller) LED connection for the
GLAN port is located on pins 11
and 12 of JF1. Attach the NIC LED
cable to display network activity.
Refer to the table on the right for
pin definitions.
Overheat/Fan Fail LED
Connect an LED to the OH connec-
tion on pins 7 and 8 of JF1 to provide
advanced warning of chassis over-
heating. The LED will blink as long
as an overheat condition exists.
Refer to the table on the right for pin
definitions.
Power Fail LED
The Power Fail LED connection is
located on pins 5 and 6 of JF1. Refer
to the table on the right for pin defi-
nitions.
GLAN1 (Ethernet Port)
A gigabit Ethernet port (designated
LAN1) is located on the I/O
backplane. This port accepts RJ45
type cables.
Chapter 5: Advanced Serverboard Setup
Overheat (OH) LED
Number
Power Fail LED Pin
Pin
Number
5-13
HDD LED Pin
Definitions
(JF1)
Pin
Number
Definition
13
Vcc
14
HD Active
NIC1 LED Pin
Definitions
(JF1)
Pin
Number
Definition
9/11
Vcc
10/12
GND
Pin Definitions
(JF1)
Pin
Definition
7
Vcc
8
GND
Definitions
(JF1)
Definition
5
Vcc
6
GND
Advertisement
Table of Contents
