Table of Contents
Advertisement
S
W
UPER
ORKSTATION 7034A-T/7034A-i Manual
Power LED/Speaker/Keylock
On the JF2 header, pins 1, 3, 5 and
7 are for the speaker, pins 2, 4 and
6 are for the power LED and pins 8
and 9 are for the keylock. See the
table on the right for speaker pin
definitions. Note: The speaker con-
nector pins are for use with an ex-
ternal speaker.
the onboard speaker, you should
close pins 5-7 with a jumper.
Wake-On-Ring
The Wake-On-Ring header (desig-
nated JWOR) allows your computer
to receive and "wake-up" by an in-
coming call to the modem when in
suspend state. See the table on the
right for pin definitions. You must
have a Wake-On-Ring card and cable
to use this feature.
Wake-On-LAN
The Wake-On-LAN header is located
at JWOL. See the table on the right
for pin definitions. You must enable
the LAN Wake-Up setting in BIOS to
use this function. (You must also
have a LAN card with a Wake-On-
LAN connector and cable.)
SATA LED Header
(X6DAL-TG only)
An SATA LED header is located at
JSLED. See the table on the right for
speaker pin definitions.
If you wish to use
5-16
Speaker Connector Pin
Definitions (JF2)
Pin
Number
Function
4
+
Red wire, Speaker data
5
Key
No connection
6
7
Speaker data
Wake-on-Ring
Pin Definitions
(JWOR)
Pin
Number
Definition
1
Ground
2
Wake-up
Wake-On-LAN Pin
Definitions (JWOL)
Pin
Number
Definition
1
+5V Standby
2
Ground
3
Wake-up
SATA LED Pin Definitions
(JSLED)
Pin#
Definition
1
Marvell SATA HD0 Active LED
2
Marvell SATA HD1 Active LED
3
Marvell SATA HD2 Active LED
4
Marvell SATA HD3 Active LED
5
All Marvell SATA Ports Active LED
6
Hance Rapid's SATA Active LED
7
Hance Rapid's SATA Active LED
Definition
Key
Advertisement
Table of Contents
