Panasonic Switch-M12PWR Operation Manual page 89

Available commands are listed below.
N Display the next page.
Press "N" to display the next page.
P Display the previous page.
Press "P" to display the previous page.
V Configure PVID settings.
Press "V." The command prompt changes to "Enter port number>." Enter a port
number you wish to configure. Then, the command prompt changes to "Enter
PVID for port #>." Enter VLAN ID you wish to modify among the already
configured VLAN IDs.
F Set type of receive packet.
Press "F." The command prompt changes to "Enter port number>." Enter a port
number you wish to modify. Then, the command prompt changes to "Select port
acceptable frame type (A/T)>." Enter "A" to receive all the frames, or "T" to receive
only the tagged frames, respectively.
G Configure GVRP settings.
Press "G." The command prompt changes to "Enter port number>." Enter a port
number you wish to modify. Then, the command prompt changes to "Enable or
Disable port GVRP status (E/D)>." Enter "E" to enable, or "D" to disable GVRP,
respectively.
Q Return to the previous menu.
Note: This Switching Hub is possible to assign multiple VLANs to one port.
When new VLAN was configured, it belongs to both VLAN to which
it has belonged and the new VLAN. So, when you divide the domain,
make sure to delete it from a VLAN to which it has belonged.
89