Panasonic Switch-M12PWR Operation Manual page 115

Available commands are listed below.
N Display the next page.
Press "N" to change the display to the next page.
P Display the previous page.
Press "P" to change the display to the previous page.
A Add VLAN ID to be associated to MST instance.
Press "A" to change the command prompt to "Enter MSTP instance ID>." Enter
MST instance ID. Then, "Enter VLAN ID>" is displayed. Enter VLAN ID to be
associated.
V Cancel association between MST instance and VLAN ID.
Press "V" to change the command prompt to "Enter MSTP instance ID>." Enter
MST instance ID. Then, "Enter VLAN ID>" is displayed. Enter VLAN ID to cancel
association.
R Delete MST instance ID.
Press "R" to change the command prompt to "Enter MSTP instance ID>." Enter
MST instance ID to be deleted.
M Set MST instance.
Press "M" to change the command prompt to "Enter MSTP instance ID>." Enter
MST instance ID. Then, "MST Instance Configuration" is displayed. Advanced
setting of MST instance becomes available. For configuration method, refer to the
section (4.7.4.e).
C Set MST instance for each port.
Press "C" to change the command prompt to "Enter MSTP instance ID>." Enter MST
instance ID. Then, "MST Instance Port Configuration" is displayed. Setting of MST
instance for each port becomes available. For configuration method, refer to the
section (4.7.4.f).
I Set configuration information on MST instance.
Press "I" to change the command prompt to "Enter MSTP instance ID>." Enter MST
instance ID. Then, "MST Instance Topology Information" is displayed. Setting of
configuration information on MST instance becomes available. For configuration
method, refer to the section (4.7.4.g).
Q Return to the previous menu.
115