Table of Contents
Advertisement
Available commands are listed below.
N
Show the next page.
Press "N." The screen displays the next page.
P
Show the previous page.
Press "P." The screen displays the previous page.
G
Enable IGMP Snooping.
Press "G." The command prompt changes to "Enable or Disable IGMP snooping
(E/D)>." Press "E" to enable the function. Press "D" to disable it.
U
Enable multicast filtering.
Press "U." The command prompt changes to "Enable or Disable Multicast
Filtering (E/D)>." Press "E" to enable the function. Press "D" to disable it.
C
Set IGMP snooping Querier.
Press "C." The Set Querier Configuration Menu opens. (Refer to 4.7.10.d.)
H
Set the aging time of multicast group members.
Press "S." The command prompt changes to "Enter age out time>." Set the time
between 150 and 300 seconds.
R
Set the aging time of the multicast group's router port.
Press "S." The command prompt changes to "Enter age out time>." Set the time
between 150 and 300 seconds.
I
Set the Proxy Report waiting time.
Press "I." The command prompt changes to "Enter forward interval>." Set the
time between 0 and 25 seconds.
L
Set the operation after receiving a Leave packet.
Press "L." The Set Leave Mode Menu opens. (Refer to 4.7.10.a.)
V
Set a VLAN to be filtered.
Press "V." The Show IGMP Snooping VLAN Filter Table Menu opens.
(Refer to 4.7.10.b.)
T
Show router ports.
Press "T." The Show Router Port Table Menu opens.
(Refer to 4.7.10.c.)
M Statically set a router port.
Press "M." The command prompt changes to "Add or Delete static group
member(A/D)>." Press "A" to add a router port. Press "D" to delete it. Then,
enter the target VLAN ID, multicast MAC address, and port number.
Q
Return to the previous menu.
Note: The IGMP Snooping function and the Internet Mansion mode cannot
be used simultaneously.
183
Advertisement
Table of Contents
