Panasonic Switch-M12PWR Operation Manual page 166

Z Initialize the authentication status.
Press "Z." The command prompt changes to "Select the All MAC or MAC address
(A/M) >." Press "A" to initialize all MAC addresses. Press "M" to initialize each MAC
address individually. If you press "A," the command prompt changes to "Initialize
all MAC (Y/N) >." To initialize it, press "Y." Otherwise, press "N." If you press "M,"
the command prompt changes to "Enter supplicant MAC address >." Enter the
MAC address of the supplicant you wish to initialize. Then, the command prompt
changes to "Initialize MAC **:**:**:**:**:** (Y/N) >." To initialize it, press "Y."
Otherwise, press "N."
R Initialize the re-authentication status.
Press "R." The command prompt changes to "Select the All MAC or MAC address
(A/M) >." Press "A" to initialize all MAC addresses. Press "M" to initialize each MAC
address individually. Press "A." The command prompt changes to "Would you want
to initialize re-authenticator?(Y/N)>." To initialize it, press "Y." Otherwise, press
"N." If you press "M," the command prompt changes to "Enter supplicant MAC
address >." Enter the MAC address of the supplicant you wish to initialize. Then,
the command prompt changes to "Would you want to initialize
re-authenticator?(Y/N)>." To initialize it, press "Y." Otherwise, press "N."
M Go to Port Based Access Control Configuration Menu
The command prompt changes to "Select the Port based or MAC based auth
mode (P/M) >." Enter "P." The Port Based Access Control Configuration Menu
screen appears.
S Not available for MAC Based mode
F Not available for MAC Based mode
Q Return to the previous menu.
166