Table of Contents
Advertisement
Screen Description
Port
Displays the port number.
Refresh
Displays the refresh interval.
Elapsed Time
Displays the time elapsed since resetting of the counters.
Since Reset
Counter Name
Displays each counter name.
Total
Displays values accumulated in the counters.
Available commands are listed below.
S
Change the target port of the counter value display.
Press "S." The command prompt changes to "Select Port number>." Enter the
port number you wish to display.
N
Show the values of the next port.
Press "N." The screen displays the counter values of the next port. After you
reach Port 14, you cannot go back to Port 1 by pressing "N."
P
Show the values of the previous port.
Press "P." The screen displays the counter values of the previous port. This
command is not available on the Port 1 screen.
U
Change the counter values with those accumulated since the boot.
Press "U." The counter values accumulated after resetting the counters are
immediately changed with those accumulated after the system boot.
R
Change the counter values with those accumulated after resetting the counters.
Press "R." All counter values are immediately reset to 0 and displayed.
F
Set the counter refresh mode.
Press "F." The comment line displays "1 for start to refresh, 2 for set refresh
rate." Enter 1 to cancel refresh. The refresh interval field displays "STOP," and
the display is not refreshed. Enter 2 to change the refresh interval. The
command prompt changes to "Input refresh time>." Enter an integer between
5 and 600 (seconds).
Q
Return to the previous menu.
174
Advertisement
Table of Contents
