Starting The Machine - Norton clipper CS 352 Operating Instructions Manual

VERS.2022.10.20

3.4 Starting the machine

Make sure the blade is raised clear up the ground before starting the machine.
Turn the fuel valve to the ON position.
Move the throttle control lever slightly to the left. Put the engine switch on ON, and make sure
Pull the starter grip lightly until you feel
resistance, then pull briskly.
CAUTION: Do not allow the starter grip to snap
back against the engine. Return it gently to
prevent damage to the starter.
To stop the engine, move the throttle control lever fully to the right, then turn the engine switch to
the OFF position. Turn the fuel valve to the OFF position.
16
Move the choke lever to the CLOSED position.
NOTE: do not use the choke if the engine is
warm or the air temperature is high.
the emergency switch on the board of the
machine is in the correct position.
As the engine warms up, gradually move the
choke lever to the OPEN position.
Position the throttle control lever for the
maximum engine speed.
CS352_MAN_EN