Table of Contents
Advertisement
VERS.2022.10.20
6 MAINTENANCE AND SERVICE
ATTENTION: to perform maintenance on the machine, always switch it off. Always wear a face
mask and safety goggles while performing the maintenance of machine.
6.1 Maintenance of the machine
To ensure a long-term quality from the cutting with the CS 352, please follow the maintenance
plan below:
Whole machine
Flange and blade fixing devices
Belts tension
Water hoses and nozzles
Depth screw
Engine housing
Reachable nuts and screws
Adjustment and replacement of the belts
After one hour of work, the belts heat and stretch. Therefore, you have to re-tension them.
To adjust the belts, firstly remove the belt guard by unscrewing the 2 nuts. Loose the 4 engine
bolts and shift the engine by using the two screws on the front.
To replace the belts, move the engine completely to the front. Adjust the belts and retighten them
by shifting the motor to the rear.
Always use a matched set of belts. Do not replace single belts.
Lubrication
The CS 352 uses life-lubricated bearings. Therefore, you don't need to lubricate them at all.
Grease the depth screws every day.
Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work.
Regular service period
Perform
at
every
indicated period
Visual control (general
aspect, watertightness)
Clean
Clean
Control
Clean
Grease
Clean
Tighten up
CS352_MAN_EN
19
Advertisement
Table of Contents
