Norton clipper CS 352 Operating Instructions Manual page 11

VERS.2022.10.20 CS352_MAN_EN
The precisely manufactured blade shaft is fitted into two heavy-duty self-aligning pillow block
bearings, including grease nipples.
The steel belt guard (5) is a sealed two pieces unit. The backing plate is bolted to the mainframe
of the machine and two locking nuts are welded to it. The outer guard, covering the three drive
belts and taper lock pulleys, is held in place by two locking bolts.
The pointer (6) allows the operator to make precise cut easily.
The water tank (7), with a capacity of 25 litres, can be easily removed from the machine, allowing
the tank to be refilled without having to move the machine.
The machine has a GX200 Honda engine (9), with 6,5HP. An emergency shut down switch (8)
near the levers allows an immediate stop of the machine in case of danger.
11