Safety Instructions For Particular Operating Phases - Norton clipper CS 352 Operating Instructions Manual

VERS.2022.10.20

1.3 Safety instructions for particular operating phases

Before commencing work

Before commencing work, make yourself familiar with the working environment at the place
of use. The working environment includes: obstacles in the area of work and manoeuvre, the
firmness of the floor, necessary protection at the site relating to public thoroughfares and the
availability of help in the event of accidents.

Check for correct mounting of the blade regularly.

Immediately remove damaged or badly worn blades, as they endanger the operator whilst
rotating.

Only fit NORTON diamond blades to the machine! The use of other tools can damage the
machine!

Attention is drawn to the use of BS2092 safety goggles in conformity with specified Processes
No.8 of the Protection of Eyes Regulation 1974, Regulation 2(2) Part 1.

For security reasons, never leave the machine unattended, untied or unlocked.
While the engine is running

Do not move the machine whilst the blade is running idle.

Always cut with the blade guard in position.

Apply cooling water continuously whilst cutting and in good time!
Petrol powered machines:

Always use the fuel advised.

In confined areas, exhaust gases should be evacuated and the job site properly aerated.

Petrol and diesel machines, which by their nature emit toxic exhaust gases, must not be used
in places prohibited by the Health at Work etc. Act 1974 or which are prohibited by Factory
Inspectors or Safety Officers.

Fuel is flammable. Before filling the tank, shut down the engine, extinguish all open flames
and do not smoke. Take care that no petrol is spilled on any motor part. Always wipe up spilled
fuel.
8
CS352_MAN_EN