Norton clipper CS 352 Operating Instructions Manual page 21

VERS.2022.10.20
Air cleaner
The CS 352 has a Cyclone filter.
To service the air cleaner filter, follow these
instructions:

Remove the nut, air cleaner cover and
wing nut.

Remove the pre air cleaner elements
and separate them.

Carefully check both elements for holes
or tears and replace if damaged.

Paper element: tap element lightly
several times on a hard surface to
remove excess
compressed air lightly through the filter
from the inside out. Never brush the dirt
off; brushing will force dirt into the
fibres.

Foam element: clean in warm soapy
water, rinse and
thoroughly. Dip the element in clean
engine oil and squeeze out all the
excess. The engine will smoke during
initial start-up if too much oil is left in the
foam.

Shine a light through the elements, and
inspect them carefully. Reinstall the
elements if they are free of holes and
tears.
Fuel strainer cup
To service fuel strainer cup, follow these
instructions:

Turn off the fuel valve and remove the
strainer cup.

Clean the strainer cup with solvent.

Install the O-ring and strainer cup.

Tighten the strainer cup to 4N.m.
dirt or blow
allow to dry
CS352_MAN_EN
21