Idis DR-2516P Operation Manual page 69

on the remote control or right-click on the mouse to
open up the Zone Setup menu.
– Select: Confirm the block selection in the selection
window.
– Clear: Clear the block selection in the selection
window.
– Reverse: Clear the blocks selected within the
selection window and select all unselected blocks
within the selection window.
– Select All: Select all blocks.
– Clear All: Clear all block selections.
– Reverse All: Clear all selected blocks within the
screen and select all unselected blocks within the
screen.
– OK: Save the changes and exit the menu.
– Cancel: Exit the menu without saving the changes.
● Setup
– Sensitivity: Set daytime and nighttime sensitivity
settings between 1 (Low) and 5 (High).
– Min. Blocks: Motion needs to be detected in more
than the specified number of blocks in order to
trigger a Motion Detection event. You may select a
value between 1 and the number of blocks selected
under Zone for daytime and nighttime, each.
– Ignoring Interval: The system does not produce
event log entries or remote notifications for motion
detected within a certain period of time after the
motion of the camera channels is detected. Set the
value between 1 sec and 5 secs or choose Never.
Ignoring Interval does not affect motion detection
recording.
– Daytime Setup: Specify when daytime starts
and ends. Adjust the time frame in 15-minute
increments. Times outside the specified range will
be assumed as nighttime by the system.
– Detecting motion in PTZ movement: It can be set
to detect events during PTZ operation.
● Condition: When a specific event occurs, you can set
the condition that determines whether to operate
motion according to the status of other events.
– Reference Only: Set the event to be the subject of
a reference.
– Event: Set the reference event.
– Channel: Set the reference channel.
● Actions: Specify which actions to take when motion
is detected.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Configure to be notified of events by Mail,
LAN1 through 5, Push, HTTP, FTP, and/or Alert
Window.
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
Part 2 - Configuration
69