Rtsp; Firewall - Idis DR-2516P Operation Manual

Part 2 - Configuration

RTSP

RTSP service allows you to monitor real-time using the
Real-Time Streaming Protocol.
● RTSP Port: Set the port number of the RTSP server
obtained from your system administrator.
● RTP Port: Set the start/end port number of the RTP
server obtained from your system administrator.
• You can access a remote NVR and monitor
live video images using media players, such
as VLC Player, supporting RTSP service. Start
the media player on your local PC and enter
"rtsp://ID:Password@IP address:RTSP port
number/trackID=channel number" (e.g.: rtsp://
admin:@10.0.152.35:554/trackID=1)
• Video display on certain media players may not
be smooth depending on the network status.
• RTSP service might not be supported, depending
on the type of media player.
104

Firewall

Setting up a customized firewall rule set, it allows or
denies access such as specific MAC address, IP address
and receiving network port of the NVR.
Select Use Firewall to activate firewall function. Click
the + icon at the bottom of the list to set up a firewall
rule.
● Title: Edit the name of the rule.
● Type: Set the IP address, the MAC address or the
network port.
● Action: Select which actions to apply this firewall rule
to.
– Drop: Discard the packet that matches all the
specified conditions.
– Reject: Deny the packet that matches all the
specified conditions and send back an ACK packet
telling it that the "packet was dropped" to the
sender.
– Accept: Allow the packet that matches all the
specified conditions.
● Interface: Specify the ethernet interface. It refers to a
WAN (Network Client) or VIN (Video-In).
● Mac Address: If the rule is set to MAC address, enter
the sending MAC address
● IP: If the type of the rule is set to IPv4 or within the
IPv4 scope, enter the sending IP address.
● Port: If the type of the rule is set to port or within the
port scope, enter the receiving network port number
of NVR.