Idis DR-2516P Operation Manual page 74

Part 2 - Configuration
– Zone Title: Select the zone to change the settings.
When selecting the zone, a check mark appears to
the left.
– Clear: Clear the selected zone.
– Undo: Remove the last point of a line.
– Edit Name: Change the name of the zone.
– Object: Select an object to detect.
– Add: Add a zone.
– Delete: Delete the selected zone.
– Delete All: Delete all zones.
– Save: Save the changes and exit the menu.
– Cancel : Exit the setup screen without saving the
changes.
● Ignore Condition: Set the condition to ignore them
when the events occur.
– Ignore Condition: The system does not produce
event log entries or issue remote notifications
regarding event for the specified time after the
initial event was detected. Set the value between 1
sec and 5 secs or choose Never. Ignore Condition
does not affect Object Detection recording.
– Use Ignoring Time: Object Detection function will
be disabled during the specified time.
● Actions: Specify which actions to take when the
function is detected.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
74
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
• In order to use the Callback feature, the NVR
must be registered on the remote program.
● When the analytic type is set to Object
Detection in the Device - VA Box- Setup
tab, Use Ignoring Time option is not
dispalyed on the screen.
● To use the IDLA function, you need to set
up a time-lapse or pre-event recording
schedule in advance. Otherwise, the video
may not be displayed when searching the
event log.