Va Box_Mask Rule Violation; Va Box_Queue Congestion - Idis DR-2516P Operation Manual

VA Box_Mask Rule Violation

The camera detects a face and events occur according to
Mask Rule Violation settings.
● Setup : Check the rules for wearing a mask on a person's
face and set the event to occur when a violation occurs.
- Detection Type : Set the Non-Mask / Mask Rule.
- Ignoring Interval : Event log and remote notification
are not performed for mask rule violation events
detected within a certain period of time after the
event was detected.
To use the mask rule violation, the mask rule
violation must be set on that channel.
● Actions: Specify which actions to take when an event
occurs.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–Notify: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.

VA Box_Queue Congestion

The camera detects queue congestion and events occur
according to Queue Congestion settings.
● Setup : Set congestion level to issue an alert by
detecting a queue in real time.
- Mid Congestion : Set the mid congestion level for
each selection area. You can check the information
analyzed on the basis of exceeding the set value on
remote program.
- High Congestion : Set high congestion level for each
selection area. You can check the information analyzed
on the basis of exceeding the set value on remote
program.
The event occurs only when High Conestion
function is set.
● Actions: Specify which actions to take when an event
occurs.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–Notify: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
Part 2 - Configuration
85