System; Storage - Idis DR-2516P Operation Manual

System

This screen displays an overview of system events.
When an event occurs, the corresponding channel
flashes for 5 seconds.
● Panic Record: Displays event status based on current
Panic Record status.
● Check Recording: Displays event status based on
System Monitoring settings. For more information,
refer to the Video-Analytics_Motion on page 68.
● Disk Almost Full/Disk Full: If the storage device is
not in Recycle status, event status is displayed when
the amount of disk space specified under System
Monitoring is reached and when the disk becomes
100% full. For more information, refer to the Video-
Analytics_Motion on page 68.
● Disk Partially Almost Full / Disk Partially Full: If the
storage device is not in Recycle status, event status is
displayed when a disk in one of multiple quota groups
reaches a specified capacity or disk usage reaches a
specified capacity under System - Monitoring.
● Storage Disconnected: Event status is displayed
when the storage device is abruptly disconnected.
● Disk Config Change: It will be highlighted when
the NVR reboots after the hard disk drive has been
replaced.
● No Storage Found: It will be highlighted when no
recordable storage device has been found.
● RAID Broken: Event status is displayed when the
mirroring configuration is broken. (DR-2504P-A model
only)
● Degrade: Event status is displayed when one of the
HDDs composing mirroring is in error. (DR-2504P-A
model only)
● Fan Error: Event is indicated when the cooling fan
cannot reach a certain RPM or fails for longer than 50
seconds.

Storage

Indicates each disk's status.
Configure Disk Bad and Disk Temperature settings under
Setup > System > Monitoring.
Part 2 - Configuration
115