Camera System_Camera Fan Error; Camera System_Video Loss - Idis DR-2516P Operation Manual

Part 2 - Configuration

Camera System_Camera Fan Error

The event occurs when the fan has stopped in the fan
mounted camera.
● No.: Select which cameras to apply Fan Error to.
● Actions: Specify which actions to take when a Fan
Error event occurs.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
• In order to use the Callback feature, the NVR must
be registered on the remote program.
• In case of the camera that not supports camera
system event, the camera system feature will be
disabled.
66

Camera System_Video Loss

● Activation Time: Specify how long video loss has
to last in order for it to be considered as an event.
When the video loss is not detected for the specified
duration of time, it will not be considered as an event.
● Actions: Specify which actions to take when a Video
Loss event occurs.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Configure to be notified of events by Mail,
LAN1 through 5, Push, HTTP, FTP, and/or Alert
Window.
– PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
● Ignoring Interval: The system does not produce
event log entries or issue remote notifications for
video loss detected for the time specified after the
initial video loss was detected. Set the value between
0.1 and 15 seconds or choose Never. This is supported
only when video encoders are connected.
● Use Ignoring Time: Select Time Setup to specify
the time to ignore video loss detection. Video loss
detection will be disabled for a specified time period.
This is supported only when video encoders are
connected.