Club Car Carryall 500 2015 Maintenance And Service Manual page 442

26
Axle Tubes, Axle Shafts and Wheel Bearings
2. Remove axle tube (2) from gearcase (4) (Figure 26-5, Page 26-6). See Axle Tube and Axle Shaft Removal on
page 26-6.
3. Pull oil seal (7) from gearcase (4).
AXLE SHAFT OIL SEAL INSTALLATION
1. Clean bore in gearcase (4) where new oil seal (7) will sit (Figure 26-5, Page 26-6).
2. Using an appropriate sized seal driver, drive in new oil seal (7) until 0.0393 in. (1 mm) below surface, not
fully seated.
3. Clean end of axle shaft (3) and carefully install axle tube (2) to avoid damaging new oil seal (7) with splines of
axle shaft. See Axle Tube and Axle Shaft Installation on page 26-7.
4. Refill transaxle with appropriate type and volume of oil. See Oil Change – Transaxle on page 26-2.
Page 26-8 2015 Carryall 500 and 700 Maintenance and Service Manual
TRANSAXLE (ED65): GASOLINE VEHICLES